There is another question. Regarding NVIC_SystemLPConfig and RCC_APB1PeriphclockCmd, the effect of adding these two functions and not adding these two functions is
It's different. The relevant information was not found.
I haven't done anything about low power consumption before, but the problem lies here.
What should you pay attention to about stop mode, please give me some advice.
Lavinia 发表于 January 5, 2021
If the internal clock is used, it will indeed consume more power than the external clock.
Giorgio 发表于 January 5, 2021
It should have nothing to do with the crystal oscillator, you should not go to sleep in the simulation state, test it in the offline state. The JTAG port may also have leakage current.
Caesar 发表于 January 5, 2021
If it is not so high, there must be a problem with other places or circuits. I use STM32F030R8T6 to measure, that is, the official eight discovery boards, HSI, all IO ports are set to pull-down input, and the stop mode is 31uA. Standby 4.5uA.
