I use SGM6603-ADJ to adjust the voltage of 3.5V, it can be adjusted during debugging, and it can not be drawn on the board. What is the reason?
Jenson 发表于 July 10, 2020
The capacitor should be as close as possible to the chip.
Terry 发表于 July 10, 2020
2 The foot is not grounded;
R5 of pin 3 is not grounded;
R3 of pin 4 is not grounded;
5 feet C21, 26 are not grounded
6-pin C24 and C25 are not grounded;
All ground terminals are empty.
I don't know how to add power when debugging.
Elsa 发表于 July 10, 2020
Are you just hiding the copper, there is no ground wire.